Revision 1.00 has been tested for assemblability and potential wiring problems, supports power supply via pico and a 5.5 mm x 2.1 mm DC-005 round connector (plus in the center) with a supply voltage of 5-12 volts passing through the voltage stabilizer L7805ABD2T-TR

The Bill of Materials contains resistors for HDMI, for VGA, the following resistor nominals are required:
R4 = 820R
R5 = 360R
R6 = 820R
R7 = 360R
R8 = 820R
R9 = 360R
R10 = 75R
R11 = 75R

The jp5 jumper needs to be soldered if an additional PsRam RAM chip is installed

The jp4 jumper does not need to be soldered if the AMS1117 3.3 stabilizer is planned to be installed. If it is soldered, the stabilizer built into the Rpi will be used